►
In SOPAS ET, click on the Performance options expandable menu in the right-hand
window.
►
Activate the Cross beam measuringfunction in the Scan mode area.
Figure 139: SOPAS ET - Activating cross beam measuring
✓
The dialog "Attention. Activating this function will increase the number of beams.
All beam-dependent settings must be adjusted."
►
Click Yesto activate the cross beam measuring function. Click No to cancel.
✓
The light grid display is adjusted in the middle section (beam window). The real
and virtual beams are renumbered and, as a result, the number of beams is nearly
doubled. The virtual beams are displayed as dashed lines.
►
Check the existing configuration for the Cross beam measuringfunction.
►
Adjust the configuration for the cross beam measuring function.
8
CONFIGURATION WITH SOPAS ET
142
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice
To Next Page
Loading...
