Figure 145: Start simulation
✓
The configured simulation object is moved through the MLG-2 in the Simulation
area.
Figure 146: Simulation object in Simulation area
8.10
Beam monitor (only in EXPERT function level)
If SOPAS ET is connected to an MLG-2, the Beam monitor tab shows the current beam
status as a function of time as well as the status of the configured outputs.
Figure 147: Beam status
CONFIGURATION WITH SOPAS ET 8
8018748.1Q3I/2024-12-18 | SICK O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet
147
Subject to change without notice
To Next Page
Loading...
