CAUTION
Risk of injury from protruding screw thread!
When mounting through the machine or profile frame to the QuickFix bracket, the M5
screw can present an injury risk if too long.
►
Select an appropriate screw length to prevent any risk of injury from an overrun.
Figure 35: Mount QuickFix bracket to a profile frame
Mount QuickFix bracket to the back of a device column
NOTE
The QuickFix bracket has cable routing. Depending on the installation, the cable routing
can make mounting easier.
The sender and receiver are each mounted with two QuickFix brackets.
The QuickFix bracket consists of two parts, which are pushed into each other. An M5
screw is used to join both parts and to clamp the housing (sender or receiver).
You need two M5 screws per bracket if mounting them on the back.
►
Choose the length of the M5 screw such that it is possible to clamp the housing
(sender or receiver) in the QuickFix bracket.
QuickFix bracket for the fieldbus module
If you are using the QuickFix bracket, you will need one more QuickFix bracket for the
fieldbus module.
4 MOUNTING
42
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice
To Next Page
Loading...
