Figure 36: QuickFix bracket for the fieldbus module
1
QuickFix brackets
4.3.2 Mounting the FlexFix bracket
In the FlexFix bracket (see "Accessories", page 170), the sender and receiver can be
flexibly rotated by ±15°.
FlexFix brackets can be mounted in two ways:
•
On the side
•
On the back
Mounting the FlexFix bracket on a profile frame
The sender and receiver are mounted at the designated points using two FlexFix brack‐
ets in each case.
M5 screws are inserted through the FlexFix bracket and into the machine or profile
frame for mounting. A screw nut or threaded hole is required on the machine or profile
frame.
MOUNTING 4
8018748.1Q3I/2024-12-18 | SICK O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet
43
Subject to change without notice
To Next Page
Loading...
