SICK MLG-2 ProNet - Mounting the Fieldbus Module Offset from the MLG-2

4.3.4 Mounting the fieldbus module offset from the MLG-2
1
2
Figure 42: Mount the fieldbus module offset using the QuickFix bracket
1
Mounting pins
2
QuickFix bracket
21
Figure 43: Mount the fieldbus module offset using the mounting bracket
1
Mounting bracket
2
M4 × 16
You can mount the fieldbus module offset.
►
Remove the fieldbus module as described (see figure 41, page 46).
►
Unscrew the mounting pins.
►
Mount the fieldbus module using a QuickFix bracket.
Or:
►
Alternatively, mount the fieldbus module using a mounting bracket.
Mount the mounting bracket on the fieldbus module using two M4 screws with a
maximum length of 16mm.
►
Use an M5 screw with a sliding nut, for example, to mount the mounting bracket
on an industrial profile.
NOTE
The maximum length of cable between the MLG-2 receiver and the FBM fieldbus
module/AFB connection box must not exceed 2.7m.
MOUNTING 4
8018748.1Q3I/2024-12-18 | SICK O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet
47
Subject to change without notice