SICK MLG-2 ProNet - Page 54

Test_In
Feldbusmodul
I/O
Test_In
Figure 46: T-connector for sender and fieldbus module
NOTE
If replacement is necessary, please observe replacement document 8020350
(de)/8020351 (en).
Table 28: Pin assignment, I/O connection of the T-connector
Male connector Pin Signal Meaning
1 L+ 24V supply voltage
2 Test_In Test input
3 M GND supply voltage
4 Q1 Switching output 1
5 Not connected Not connected
5 ELECTRICAL INSTALLATION
54
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice