Instructions to action
►
The arrow denotes instructions to action.
1. The sequence of instructions is numbered.
2. Follow the order in which the numbered instructions are given.
✓
The tick denotes the results of an action.
O, Ö, o
LED symbols describe the status of a diagnostics LED. Examples:
O
The LED is illuminated continuously.
Ö
The LED flashes evenly.
ôKõ
The LED flashes briefly.
o
The LED is off.
s r Sender and receiver
In figures, the symbol s indicates the sender and r indicates the receiver.
1.4
Abbreviations used
BNB Beam Number Blocked
BNM Beam Number Made
CBB Central Beam Blocked
CBM Central Beam Made
FBB First Beam Blocked
FBM First Beam Made
GSD Device data sheet
IDI Inside Dimension
LBB Last Beam Blocked
LBM Last Beam Made
MDA Minimum Detectable Absorption
MDO Minimum Detectable Object
MLG-2 Measuring automation light grid 2
MOL Minimum Detectable Object Length
MSB Most Significant Bit
NBB Number of Beams Blocked
NBM Number of Beams Made
NCBB Number of Consecutive Beams Blocked
NCBM Number of Consecutive Beams Made
ODI Outside Dimension
RLC Run-length code
SDD SOPAS Device Description
PLC Programmable logic controller
1 ABOUT THIS DOCUMENT
8
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice
To Next Page
Loading...
