SICK MLG-2 ProNet - Parameters with Auxiliary Resources and Diagnostic Options

Operator
0 equates to =
1 equates to ≥
2 equates to ≤
3 equates to ≠
Operand 2
0…510
7.4.2.5 Energy saving mode
Table 90: Energy saving mode
Index Access Data type Description
64h R/W BOOL This parameter is used to activate standby
mode.
0 = standby not active
1 = standby active
In order to reduce energy consumption, the MLG-2 can be set to standby mode.
Standby mode freezes the status of the outputs, i.e., they do not change their status
even when objects enter or leave the detection area.
7.4.2.6 Switch-off delay
You can use the switch-off delay to adjust the output from the switching outputs so
that it matches the installed PLC. You can set one individual switch-off delay each for
switching outputs Q1 through Q4, and one shared switch-off delay for switching outputs
Q5 through Q16.
The delays set here also affect the bits in the process data QS – Switching Output Status .
Table 91: Switch-off delay
Index Access Data type Description
65h R/W UINT-16 This parameter is used to set a delay for
switching output Q1.
66h R/W UINT-16 This parameter is used to set a delay for
switching output Q2.
67h R/W UINT-16 This parameter is used to set a delay for
switching output Q3.
68h R/W UINT-16 This parameter is used to set a delay for
switching output Q4.
69h R/W UINT-16 This parameter is used to set a shared delay
for switching outputs Q5 through Q16.
7.4.3 Parameters with auxiliary resources and diagnostic options
7.4.3.1 Alignment aid
Table 92: Alignment aid
Index Access Data type Description
70h R/W BOOL This parameter activates the alignment aid of
the MLG-2.
0 = alignment aid not active
1 = alignment aid active
7 THE MLG-2 ON THE PROFIBUS NETWORK
86
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice