EasyManua.ls Logo

SICK MLG-2 ProNet - Configuration with SOPAS et; Preparation; Installing the Software; Device Selection

SICK MLG-2 ProNet
180 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8 Configuration with SOPAS ET
8.1 Preparation
8.1.1 Installing the software
SOPAS ET 3.0 or higher is required for configuring the MLG-2.
The latest version of SOPAS ET can be found at www.sick.de > Search > SOPAS.
Observe the system requirements for SOPAS ET. These are mentioned on the download
website:
Run the setup.exe from the download website.
Follow the instructions in the Setup wizard.
Ethernet settings
The MLG-2 is shipped with the following IP network configuration:
Static IP address. DHCP deactivated.
IP address: 192.168.200.100
Subnet mask: 255.255.255.0
You can change the IP network configuration in SOPAS ET.
If you would like the MLG-2 to acquire an IP address from a DHCP server, DHCP must
be activated. If the MLG-2 is unable to locate a DHCP server, the MLG-2 will use the IP
address 192.168.200.100.
Starting the software
Use the application SICK > SOPAS Engineering Tool > Sopas from the Start menu to
configure the MLG-2.
8.1.2 Device selection
A SOPAS Device Description (SDD) is required in order to configure the MLG-2.
Detecting a connected device
When an MLG-2 is connected to the PC/notebook via Ethernet, the SDD can be loaded
directly from the device and SOPASET will detect the MLG-2 type automatically.
Configuring a device offline
Alternatively, you can select the MLG-2 type offline using the device selection wizard. To
do this, you must load the SDD from the Internet. This requires an Internet connection.
You can either enter the type code of the MLG-2 directly into the device selection wizard
or define the following criteria:
Monitoring height
Maximum sensing range
Interface (number and type of inputs and outputs)
Size of the smallest object in the application
Once you have selected the desired MLG-2, the configuration interface/wizard starts
up.
NOTE
If you configure a device offline, you must then connect the PC to the MLG-2 and
download the MLG-2 configuration.
8 CONFIGURATION WITH SOPAS ET
94
O P E R A T I N G I N S T R U C T I O N S | MLG-2 ProNet 8018748.1Q3I/2024-12-18 | SICK
Subject to change without notice

Table of Contents

Related product manuals