32
SICK MSL
8 007 653/09-04-01 Technical Description • MSL © SICK AG • Safety Systems • Germany • All rights reserved
13 Accessory selection table
13 Accessory selection table
Type Designation Part number
Mounting bracket
Sliding nuts (sliding block), pack of 4 *) 2 017 550
Sliding nuts, additional, single 5 305 719
Mounting kit 1: Mounting bracket rigid, x4 7 021 352
Mounting kit 2: Mounting bracket hinged, x4 2 017 751
Mounting kit 3: Mounting bracket hinged, vibration damped, x4 2 017 752
Mounting kit 4: Mounting bracket hinged, vibration damped and shock-absorbing, x4 2 018 742
24 V power pack
120/230 V AC, 2.5 A 6 010 361
120/230 V AC, 4 A 6 010 362
Laser alignment aid
AR 60 1 015 741
Adapter AR 60 MSL/FGS, click-on 4 030 282
Connection
Terminal chamber with PG cable gland, PG 13.5, side PG 9 (x2)
Interconnectron design
Equipment plug, crimped, attached to terminal chamber
for sender unit (9-pin) 2 017 536
for receiver unit (12-pin) 2 017 537
for receiver unit (12-pin), angled **) 2 017 755
Cable receptacle
for sender unit, straight, 9-pin 6 008 440
for receiver unit, straight,12-pin 6 008 441
Harting design R 15
Equipment plug, crimped, attached to terminal chamber
for sender unit, straight 2 018 549
for receiver unit, straight 2 018 550
for sender unit, angled 2 019 081
for receiver unit, angled 2 018 551
Cable receptacle
for sender and receiver unit, for cable dia. 11 - 15 mm 6 011 105
for sender and receiver unit, for cable dia. 15 - 20.5 mm 6 011 058
Hirschmann design
DIN equipment plug (DIN 43651), attached to terminal chamber
for sender unit, 6-pin + PE 7 021 354
for receiver unit, 6-pin + PE, contamination signalling output not connected 2 018 539
for receiver unit, 11-pin + PE 2 018 584
Cable receptacle
for receiver unit, straight, 6-pin + PE 6 006 612
for receiver unit, angled, 6-pin + PE 6 006 613
for receiver unit, 11-pin + PE, straight, with crimp contacts 6 020 757
for receiver unit, 11-pin + PE, angled, with crimp contacts 6 020 758
*) Four sliding blocks supplied with each sender and each receiver
**) Specially recommended when using the MSM
The basic specification is highlighted in gray. The connector system must be ordered separately.
To Next Page
Loading...