SICUREZZA COMPAGNIE RIUNITE
2.1 - INTRODUCTION
2.2 - HEIGHT ADJUSTMENT
- Any improper use not in compliance with the reference standards shall make the user
solely responsible for any personal harm and invalidate the warranty conditions.
- In order to provide adequate protection, this hardhat must be adjusted to the head size
of the user.
- The hardhat has been designed to absorb the energy of an impact by destroying or
partially damaging the cap and the harness; even if this damage may not immediately
be visible, any hardhat that has been subjected to strong impact must be replaced.
- For your own safety it is advisable to familiarise yourself with the adjustment systems
before using the hardhat. Make several adjustments and fasten and unfasten the
retention system several times so that these actions become instinctive.
Adjust the hardhat in height by changing
the depth of the suspension mesh as fol-
lows:
Release the rear tabs of the mesh fastened
with Velcro and slide them in the slots on
the harness.
To Next Page
Loading...
Need help?
General