SICUREZZA COMPAGNIE RIUNITE
3.3 - HARDHAT CLEANING AND CARE
After each use, put the hardhat in its bag or in a closed place (e.g. locker) away from light
and humidity.
Clean the hardhat as follows:
- Never clean the hardhat in the sun.
- Disassemble the hardhat as described in Chapter 3.1
- Clean all the parts inside and out using only neutral soap and lukewarm water.
- Leave to dry at room temperature.
DO NOT USE DRYERS.
- Before reassembling the hardhat, check that all the parts are completely dry.
- Never use abrasive or strong alkaline detergents.
- When the hardhat is completely dry, reassemble it as described in Chapter 3.2
IMPORTANT
Never use solvents or organic liquids such as petrol or alcohol!
3.4 - INSPECTION PROCEDURE
Inspect the hardhat before and after each use, paying particular attention to all the fas-
tening points (harness and retention system). Immediately replace any worn and/or dam-
aged parts, exclusively using spare parts supplied by Sicor S.p.A., since only the original
spare parts are homologated and guarantee conformity of the hardhat.
- Check that there are no colour changes and/or cracks on the cap and harness.
- Check that there are no cuts and/or breakage at the edges and the holes
- Check that the suspension system is intact by checking the seams.