4
MHS400 smart Installation and operating instructions
05.2017
1. General information
Please read these installation and operating instructions carefully and in full before commissioning
the HS system MHS400 smart.
1.1 Target group of this documentation
• This documentation is intended for use by specialists and end users.
• All instructions concerning installation, commissioning and repairs contained in this document are to be performed
exclusively by electricians with training and experience in the installation, commissioning, maintenance and servicing of
motorised drives.
• All instructions on operation, care and maintenance as well as the rectification of malfunctions described here are
intended for specialists end users.
• Following installation, the installation company must hand over the installation and operating instructions to the end user
and brief the user/owner of the building accordingly.
1.2 Intended use
• The MHS400 smart system uses an electric motor to open and close windows and patio doors with lift-slide hardware
(e.g. PORTAL HS).
• The standard MHS400 smart system is not suitable for use in swimming pools and/or damp rooms. Special designs are
possible and permitted only upon request and after having been tested by SIEGENIA.
• The MHS400 smart must only be operated with hardware and genuine accessories from SIEGENIA (hardware from
third-party manufactures upon request).
• It must be possible to access and disassemble the slide drive SA at all times should maintenance and service work be
required (curtain rods, lamps, ceiling covers, roller shutter housings, etc. must not hinder removal).
• The instructions contained in ASR A 1.6, VFF data sheet KB.01 as well as EN 12453 for power-operated windows, doors
and gates must be observed!
• If you are using the system for commercial purposes, you must also observe the safety instructions of your accident
insurance provider.
• Following installation of the MHS400 smart, you must carry out a reference run as well as a calibration and teach-in run
when the unit is commissioned for the first time.
1.3 Incorrect use
• Lift and slide elements that are equipped with the MHS400 smart HS system must not be used as escape doors/
emergency exits in the event of a fire!
• Any use of this product that is not in accordance with its correct use, or any adaptation of or modification to the product
and its associated components for which the express consent of SIEGENIA has not been obtained, is strictly prohibited.
SIEGENIA accepts no liability whatsoever for any material losses or injury to people caused by failure to comply with this
stipulation.
1.4 Dimensions
• All the dimensions in this documentation are specified in mm.
To Next Page
Loading...
General