Motor Components (Options)
4.5 Holding brake (option)
4.5 Holding brake (option)
For a description of the function, refer to the Configuration Manual "General Section for
Synchronous Motors".
The holding brake cannot be retrofitted! Motors with holding brake are longer by the mounted
space required (refer to the dimension drawing).
Table 4-12 Technical data of the holding brakes used for 1FT6 motors
Motor type Brake type Holding torque
M4
1)
Direct current Opening time
with varistor
Closing time
with varistor
Highest
switching
energy
[Nm] [A] [ms] [ms] [J]
1FT602 EBD 0.11 B 1 0.3 20 10 9
1FT603 EBD 0.15 B 2 0.4 30 15 27
1FT604 EBD 0.4 BA 5 0.8 50 20 125
1FT606 EBD 1.5 B 15 0.8 130 30 320
1FT6081 EBD 1.2 B 15 0.8 150 35 750
1FT6082 EBD 1.2 B 15 0.8 150 35 750
1FT6084 EBD 3.5 BN 28 0.9 180 35 1600
1FT6086 EBD 3.5 BN 28 0.9 180 35 1600
1FT610 EBD 4 B 70 1.4 220 50 2100
1FT613
2)
EBD 8 B 140 1.7 300 90 9800
1)
Standardized acc. to VDE 0580 with varistor circuitry
2)
not for water cooling
Holding torque M
4
The holding torque M
4
is the minimum brake torque in steady-state operation (when the
motor is at a standstill).
1FT6 synchronous motors
4-12 Configuration Manual, (PFT6), Edition 12.2004, 6SN1197-0AD12-0BP0
To Next Page
Loading...
