38
External antenna connection
To enable long-range wireless connection to
the SCADA control center, it will be
necessary for the user to fit an appropriate
external antenna. The antenna cable is
passed through a cable gland at the rear of
the RCU enclosure (item D in Figure 3 on
page 10) and connected to the user’s radio
equipment. The cable gland must be
tightened to clamp the cable. It may be
desirable to fit an antenna surge arrestor
inside the RCU enclosure. The surge arrester
must be grounded to the 6 mm ground stud
inside the RCU enclosure.
Item Description
A Antenna radio cable gland
B Antenna radio cable
C Antenna surge arrester
A
B
Figure 33: Antenna cable connection
C
RCU Connect installation instructions
RCU Connect is supplied as a setup file
which will self-install on the PC running the
following Windows® operating systems:
1. Windows® 7
2. Windows® Vista
3. Windows® XP – service pack 3 or higher.
When first run, the user is guided to select
the Windows® folder that will hold the
utility’s configuration files. The default
folder is /Siemens/RCU Connect/ created
under the user’s application data folder in
Windows®. It is recommended to use the
default location.
File Description
dotNetFx40_Client_
x86_x64.exe
An executable file for
the installation on a PC
RCUConfigureSetup.exe
An executable file for
the installation on a PC
USB2Drivers.zip
The zip file includes
drivers for various
systems
RCU Connect
instructions.pdf
A separate manual with
these installation
instructions
Table 4: RCU Connect files
The installation sequence is as follows:
4. Install .NET
5. Install RCU Connect software.
6. Install drivers.
7. Check operation.
Install .NET
The .NET framework is normally already
installed on Windows 7 operating systems.
For Windows XP and Windows Vista, it may
be necessary to do an installation. Launch
the installation by clicking on the executable
file (dotNetFx40_Client_x86_x64.exe) and
following the Windows installation
instructions.
To Next Page
Loading...
