Transport, storage and packing
12 9229 9992 176 0D
2013-07-08
Transporting without
brackets
• Only lift the vacuum circuit-breaker so that all sling gear is tensioned.
• Remove angle plate and bracket screws from the pallet.
• Lift the vacuum circuit-breaker from the pallet.
• Remove all screw connections from the brackets on the pole plate and the
terminals.
• Remove angle plate below mechanism box.
• Transport to installation site or leave suspended from crane for further
work steps.
Fig. 12 Removing screws from the pallet Fig. 13 Removing the angle plate and brackets
Note
Keep partitions and accessory pack ready for the installation.
To Next Page
Loading...
