Mounting and connecting the device
3.2 Mounting the device
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA
37
3.2.3 Fastening the built-in device with mounting clips
Requirement
● All packaging components and protective films have been removed from the device.
● The following material and tools are available:
– The mounting clips from the accessory kit
– One torque screwdriver with cross-tip insert, size 2
Procedure
Note
If the mounting seal is damaged, the degree of protection
is not guaranteed.
1. Insert the device into the mounting cutout from the front.
2. Make sure that all four spring locks on the top and bottom of the device fully engage. If
necessary, gently press the device into the recess if it is not fully engaged.
To Next Page
Loading...
