Expert Functions
5.7 Triggering an output cam using the TM17 terminal module
Connection of the SINAMICS S120 to the Technology CPU
Product Information, 09/2011, A5E00480378-04
165
5.7 Triggering an output cam using the TM17 terminal module
Introduction
Digital outputs for the connection of an output cam are available at the TM15 and
TM17 High Feature terminal modules.
The following section describes the configuration of an output cam using the
TM17 terminal module.
Creating a TM17 terminal module with an output cam
Prepare your project as described in the "Commissioning (Page 15)" chapter of
this product information so that an appropriate HW Config hardware configuration and a
NetPro network configuration are present. At least a drive and an axis must be created in
S7T Config.
To trigger an output cam using the TM17 terminal module:
● Include a TM17 terminal module in the SINAMICS topology
● Create the function of the output cam
● Extend the S7 user program.
Connect the supply voltage to the TM 17 terminal module.
To Next Page
Loading...
Need help?
General
