Keypad
The keypad is used to set the flowmeter. The keys function as follows:
TOP UP KEY This key (when held for 2 sec.) is used to switch between op‐
erator menu and setup menu. In transmitter setup menu, a
short press will cause a return to previous level.
FORWARD KEY This key is used to step forward through the menus. It is the
only key normally used by the operator.
BACKWARD KEY
This key is used to step backwards through the menus.
CHANGE KEY With this key settings or numerical values are changed.
SELECT KEY With this key figures to be changed are selected.
LOCK/UNLOCK
KEY
This key enables the operator to change settings and it gives
access to submenus.
6.3 Menu structure
Note
Menus disabled on MAG 5000/6000 CT
Due to legal requirements, some parameters are disabled on MAG 5000/6000 CT.
The menu is built up of two parts. An operator
menu and a setup menu, see Transmitter menu
overview (Page 79).
Operator menu
The operator menu is for daily operation. It is customized in the operator menu setup. The
transmitter always starts up in operator menu No. 1. The forward
and the backward keys
are used to step through the operator menus.
Setup menu
The
setup menu is for commissioning and service only. Access to the setup menu is gained by
pressing the top up key
for 2 seconds. The setup menu operates in two modes:
●
View mode
● Setup mode
View mode is a read-only mode. The pre-selected settings can only be scanned.
Setup mode is a read and write mode. The pre-selected settings can be scanned and changed.
Access to the setup mode is password-protected. The factory set password is 1000.
Access to a submenu in the setup menu is gained by pressing the lock key
. Press the top
up
key
briefly to return to the previous menu. Press longer (2 sec.) to exit the setup menu and
return to operator menu No. 1.
Commissioning
6.3 Menu structure
SITRANS FM MAG 5000/6000 IP67
Operating Instructions, 12/2019, A5E02338368-AD 43
To Next Page
Loading...
