Digital output
Digital output can be used to configure various settings:
●
Pulse (volume/pulse, pulse output, pulse width, pulse polarity, and time constant),
see Digital output - pulse (Page 83).
● Frequency (frequency output, max frequency, and time constant), see Digital output -
frequency (Page 84).
● Error settings (level and number), see Digital output / Relay output - Error level (Page 84)
and Digital output / Relay output - Error number (Page 84).
● Limit settings (number of setpoints, setpoint settings, and hysteresis), see Digital output /
Relay output - Direction/limit (Page 85).
● Batch settings (quantity, time and counter settings, and time constant), see Digital output /
Relay output - Batch (Page 85).
Note
Batch settings
Only MAG 6000.
Not available in MAG 5000, MAG 5000 CT and MAG 6000 CT.
Note
When relay is set to batch function, pulse/frequency is not available on digital output.
Relay outputs
Relay output can be used to configure various settings:
●
Error settings (level and number), see Digital output / Relay output - Error level (Page 84)
and Digital output / Relay output - Error number (Page 84).
● Limit settings (number of setpoints, setpoint settings, and hysteresis), see Digital output /
Relay output - Direction/limit (Page 85).
● Batch settings (quantity, time and counter settings, and time constant), see Digital output /
Relay output - Batch (Page 85).
● Cleaning (cycle time), see Relay output - Cleaning (Page 85).
Note
Batch settings
Only MAG 6000.
Not available in MAG 5000, MAG 5000 CT and MAG 6000 CT.
Note
Cleaning
If
a cleaning unit is installed together with transmitter, relay output must always be used to
operate this unit. It cannot be used for other purposes.
Operating
7.1 Output settings
SITRANS FM MAG 5000/6000 IP67
52 Operating Instructions, 12/2019, A5E02338368-AD
To Next Page
Loading...
