Siemens 7ME6910 - Page 64

Error
No.
Error text
Remedy text
Comment Output
status
Input
status
42
P42 - Current output
Check cables Current loop is disconnected or the loop resistance is
too big
Active Active
43
P43 - Internal error
Switch off and on Too many errors occurred at the same time.
Some errors are not detected correctly
Active Active
44
P44 - CT SENSORPROM®
Replace SENSORPROM
®
unit has been used as CT version Active Active
49
P49 - Protection violation
Switch off and on
Internal protection of the device has been violated. Active
60
F60 - CAN comm. error
Transmitter/AOM CAN bus communication error. An add-on module,
the display module or the transmitter is defective
Zero Inactive
61
F61 - SENSORPROM® error
Replace It is not possible to rely on the data in SENSOR‐
PROM
®
unit anymore
Active Active
62
F62 - SENSORPROM® ID
Replace The SENSORPROM
®
unit ID does not comply with
the product ID.
The SENSORPROM
®
unit is from another type of
product SITRANS F C, SITRANS F US etc.
Zero Inactive
63
F63 - SENSORPROM®
Replace It is not possible to read from the SENSORPROM
®
unit anymore
Active Active
70
F70 - Coil current
Check cables Coil excitation has failed Active Active
71
F71 - Internal error
Replace transmitter Internal conversion error in ASIC Active Active
Symptom Output sig‐
nals
Error code Cause Remedy
Empty display Minimum 1. No power supply Power supply
Check
MAG 5000/6000/6000 I for ben‐
ded pins on the connector
2. MAG 5000/6000/6000 I de‐
fective
Replace MAG 5000/6000/6000 I
Diagnostics and Troubleshooting
9.2 List of error numbers
SITRANS FM MAG 5000/6000 IP67
64 Operating Instructions, 12/2019, A5E02338368-AD