Siemens 7PG21 Solkor Rf - Panel Fixing Screws; Vedette Cases; Crimps; Panel Fixing

7PG21 Solkor Rf Installation
4.1.2 Panel Fixing Screws
Typical mounting screw kit per Relay)
Consists of 4 off M4x10mm Screws
4 off M4 Nuts
4 off M4 Lock Washer
Typical rear terminal block fixing kit (1kit per terminal block fitted to relay) Consists of:
28 x M4, 8mm Screws
28 x M4 Lock Washer
4.2 Vedette Cases
4.2.1 Crimps
M5 Ring tongued crimps are recommended.
4.2.2 Panel Fixing
Vedette case mounting arrangement is shown in Figure 4.
4.3 Back of Panel cases
4.3.1 Crimps
M6 Ring tongued crimps are recommended.
4.3.2 Mounting arrangement
Case mounting arrangement is shown in Figure 5 & 6
©2010 Siemens Protection Devices Limited Chapter 5 Page 4 of 7