If the module slot is not yet provided with modules, proceed as follows:
•
Select the desired communication module in the rear view of the device.
•
Select the module from the catalog and drag it to a channel. Thus is the channel configured with a
module. DIGSI 5 indicates whether the module can be used for protection communication under Device
Information.
•
Use the Communication protocols text box to select the protection interface. A text box entitled Protec-
tion interface will then appear (see Figure 3-51).
•
Then use the Select constellation text box to select the number of devices (for example 2 devices
protection com.) (see Figure 3-52).
Device-Combination Settings
Make the device-combination settings and the settings for protection communication (see next figure).
[scconfig-181013-01, 2, en_US]
Figure 3-53
Protection Interface Initialization and Configuration
3.5.3.5
System Functions
3.5 Protection Communication
SIPROTEC 5, Overcurrent Protection, Manual 123
C53000-G5040-C017-8, Edition 07.2017
To Next Page
Loading...
