[scpmubif-210415, 1, en_US]
Figure 10-19
Information Routing in DIGSI 5
Routing Indications
The routable indication
ChannelLive
of the PMU log
•
raises when the PMU is connected to the PDC
•
clears when the connection to the PDC is interrupted.
[scparami-260912-01.tif, 1, en_US]
Figure 10-20 Log Indication for Display of the PMU/PDC Connection
Parameterizing the PMU on the Device
You can also change the PMU settings directly on the device. To do this, select the desired PMU instance on
the device display. By selecting menu item Settings you then access the editable setting values (see
Figure 10-21). Note that the parameter Port cannot be changed, because this corresponds to the physical
slot position of the communication module in question.
10.9.7
Measured Values, Energy Values, and Supervision of the Primary System
10.9 Phasor Measurement Unit (PMU)
SIPROTEC 5, Overcurrent Protection, Manual 1341
C53000-G5040-C017-8, Edition 07.2017
To Next Page
Loading...
