DIGSI 5 Display Pages
You can archive individual or all display pages of a SIPROTEC 5 device in DSP5 format. You can also use this
format to exchange display pages between SIPROTEC 5 devices. The DSP5 format is based on XML.
DIGSI 5 protocol settings for DNP3
If the DNP3 protocol is configured for a system interface, you can export the protocol settings in DIGDNP
format. The DIGDNP format is specially designed to transmit interface data from DIGSI 5 into the SICAM PAS
substation automation system.
DIGSI 5 protocol settings for IEC 60870-5-103
If the IEC 60870-5-103 protocol is configured for a system interface, you can export the protocol settings in
DIGT103 format. The DIGT103 format is specially designed to transmit interface data from DIGSI 5 into the
SICAM PAS substation automation system.
DIGSI 5 protocol settings for IEC 60870-5-104
If the IEC 60870-5-104 protocol is configured for a system interface, you can export the protocol settings in
DIGT104 format. The DIGT104 format is specially designed to transmit interface data from DIGSI 5 into the
SICAM PAS substation automation system.
DIGSI 5 protocol settings for Modbus TCP
If the Modbus TCP protocol is configured for a system interface, you can export the protocol settings in
DIGMOD format. The DIGMOD format is specially designed to transmit interface data from DIGSI 5 into the
SICAM PAS substation automation system.
DIGSI 5 Test Sequences
You can archive individual or all test sequences of a SIPROTEC 5 device in SEQ5 format. You can also use this
format to exchange test sequences between SIPROTEC 5 devices. The SEQ5 format is based on XML.
DIGSI
Configuration software for SIPROTEC
DIGT103
DIGSI 5 protocol settings for IEC 60870-5-103
File extension for a file generated by DIGSI for exporting the protocol configuration from DIGSI 5.
DIGT104
DIGSI 5 protocol settings for IEC 60870-5-104
File extension for a file generated by DIGSI for exporting the protocol configuration from DIGSI 5.
Discovery and Basic Configuration Protocol
The DCP protocol is used to detect devices without IP addresses and to assign addresses to these devices.
DNP3
DNP3 is a communications standard for telecontrol engineering. DNP3 is used as a general transmission
protocol between control systems and substations and between bay devices and the systems control.
Double Command
Double commands (DPC – Double Point Control) are process outputs which visualize 4 process states at 2
outputs: 2 defined states (for example, On/Off) and 2 undefined states (for example, disturbed positions).
Glossary
SIPROTEC 5, Overcurrent Protection, Manual 1619
C53000-G5040-C017-8, Edition 07.2017
To Next Page
Loading...
