Siemens 7SK80 - Page 419

Appendix
A.1 Ordering Information and Accessories
SIPROTEC, 7SK80, Manual
E50417-G1140-C344-A5, Release date 11.2012
419
1)
The converter requires an operating voltage of 24 VDC. If the available operating voltage is > 24 VDC the
additional power supply 7XV5810–0BA00 is required.
Port B (bottom side of device, rear) Pos. 11
not equipped 0
IEC60870-5-103 or DIGSI4/modem, electrical RS232 1
IEC60870-5-103, DIGSI4/modem or RTD box, electrical RS485 2
IEC60870-5-103, DIGSI4/Modem or RTD box, optical 820nm, ST connector 3
For further interface options, see Additional Information in the following 9
Additional information for additional ports (bottom side of device, rear, port B) Supple-
mentary
Profibus DP Slave, electrical RS485 + L 0 A
Profibus DP Slave, 820 nm, optical double ring, ST connector + L 0 B
Modbus, electrical RS485 + L 0 D
Modbus, optical 820 nm, ST connector + L 0 E
DNP3.0, electrical RS485 + L 0 G
DNP3.0, optical 820 nm, ST connector + L 0 H
IEC 60870-5-103 Protocol, redundant, electrical RS485, RJ45 connector + L 0 P
IEC 61850, 100Mbit Ethernet electrical, double, RJ45 connector + L 0 R
IEC 61850 100 Mbit Ethernet optical, double, LC connector + L 0 S
DNP3 TCP, 100 Mbit Ethernet electrical, double, RJ45 connector + L 2 R
DNP3 TCP, 100 Mbit Ethernet optical, double, LC connector + L 2 S
PROFINET 100Mbit Ethernet electrical, double, RJ45 connector + L 3 R
PROFINET 100 Mbit Ethernet optical, double, LC connector + L 3 S
Converter Order number Use
SIEMENS OLM
1)
6GK1502–2CB10 for single ring
SIEMENS OLM
1)
6GK1502–3CB10 for twin ring
Port A (bottom side of device, front) Pos. 12
not equipped 0
with Ethernet interface (DIGSI interface, RTD box connection, I/O unit connection, not IEC61850), RJ45 con-
nector
6
Measurement / Fault Recording Pos. 13
With fault recording 1
With fault recording, average values, min/max values 3