Siemens 9200 - Meter Overview; Front of Meter; Rear of Meter

Basic Setup for the Megawatt Option
7
Basic Setup for the Megawatt Option
Basic setup determines how the meter interprets the power system it is
connected to, as well as how the meter communicates with connected
networks or workstations. You can use the meter front panel or software
to perform basic setup (e.g. PT Primary, PT Secondary, and PT Scaling set
up) on a meter with the Megawatt option.
For parameter configuration through the front panel, the meter must be in
Configuration mode. Refer to “Configuration Mode” in the 9200
Installation and Basic Setup Instructions. For meter setting defaults and
values refer to “Meter Settings” on page 21.
Using configuration software, you can access the networked meter from
your workstation. Refer to “Appendix A: Communications” on page 13.
Megawatt Option Front Panel
C
B
A
Down button
Enter buttonUp button
Negative value
indicator
Infrared (IR) Port
Demand /
Peak Demand
measurements
System
measurements
x 1000 indicator
Phase
measurements
Energy readings
Phase B
Phase A
Phase C