9200 Features Guide
8
With the meter front panel, you can view parameter values; configure
parameters; perform demand resets; perform LED checks; and view meter
information. Each of these functions can be accomplished by pressing the
Up, Down, and Enter buttons on the front panel. These button actions
achieve different results according to the mode that the meter is in:
◆ Display mode (default): view parameter measurements
◆ Reset mode: reset demand measurements
◆ Configuration Select/Edit modes: configure a parameter
◆ Information mode: verify that the front panel display LEDs operate,
and view meter information, e.g, meter options, firmware version etc.
This section describes how to interpret Display mode values on a meter
with the Megawatt option. Refer to the 9200 Installation and Basic Setup
Instructions to learn about Reset, Configuration, and Information modes.
The Megawatt option displays different values than the standard meter,
but does not differ operationally for these modes.
Display Mode
C
B
A
A lit LED below A, B,
or C indicates that
the measurement has
a negative value.
Phase Measurements
:
This list displays per
phase measure-
ments (A, B, C).
System
Measurements:
This list displays
system mea-
surements.
Each line of
the display
shows a differ-
ent system
measurement.
Energy Readings
:
Parameters in this
row display energy
readings.
1
2
3
Demand / Peak
Demand (Max)
Measurements
:
This list displays
Demand and Peak
Demand (Max)
measurements.
(Min/Max mea-
surements will be
in a future release).
54
Numbers 1 – 5 rep-
resent the order that
the measurement
groups display when
you scroll in Display
mode.
You can scroll from
group to group with
the Enter button, or
from parameter to
parameter within a
group with the Up/
Down buttons.
To Next Page
Loading...
