9410 series Logging
6. Configure the waveform recording settings on the Waveform Log Setup screen:
a. Set the Waveform Depth to specify the maximum number of waveform
records stored on the meter.
b. Set the Waveform Format to specify the number of samples per cycle and
the number of cycles that are stored in a waveform record.
c. Set the Trigger Position to specify the number of cycles to capture before
the waveform versus after the waveform, using the pre-cycle arrows or the
slider
NOTE: The maximum number of cycles (pre-event + post-event) cannot
exceed the total number of cycles in the waveform format.
7. Configure your meter’s COMTRADE settings:
a. Select or clear the Generate COMTRADE files checkbox to enable or
disable the creation of COMTRADE records.
NOTE: The waveform viewer on your meter’s webpages uses the meter’s
COMTRADE files. If you want to view waveforms on the meter’s
webpages, make sure you select Generate COMTRADE files.
b. Set the Log depth for the COMTRADE files to specify the number of records
stored on your meter’s FTP site.
8. Click Finish.
You are returned to the Sag/Swell screen and the entry shows your new
configuration.
If nothing happens when you click Finish, check the log depths and buffer depths
for all your other data logs to make sure that the meter has enough memory for
these changes. Adjust the log depth and buffer depth of the data and waveform
recorders if needed.
Related Topics
• COMTRADE implementation overview
• Configuring sag/swell alarms using ION Setup
• Changing log interval and depth settings using ION Setup
Default logging framework
Your meter comes with a default logging framework, configured to record data and
events at pre-defined intervals or conditions, that should be sufficient for most
applications.
Data recorder
number
Log name Depth Interval
1 Revenue Log 3360 (35 days) 900 seconds (15 minutes)
9 Loss Log 3360 (35 days) 900 seconds (15 minutes)
2, 3, 4 Historic Logs 3360 (35 days) 900 seconds (15 minutes)
39 Daily Nominal Log 450 Triggered on demand
7, 8 Harmonics Logs 840 (35 days) 3600 seconds (1 hour)
N/A Waveform recorders (6 total) 30 Triggered on demand
N/A COMTRADE records 10 Triggered by waveform
recording (if COMTRADE
logging is enabled)
124 7EN05-0336-03
To Next Page
Loading...
