Resets 9410 series
Reset Description
Harmonics Min/Max Reset Clears all accumulated maximum and minimum harmonics values stored in the meter.
Disturbance Count Reset Clears the sag/swell event counter. The sag/swell event counter counts the number of sag/swells that have
occurred since power-up or the last reset, to provide power quality information to energy management
systems.
EN50160 Reset Clears all EN50160 parameters and statistics accumulated in the meter.
Option modules reset Resets communications to the meter’s expansion modules.
Conditional energy reset Clears the conditional energy values stored in the meter.
Input metering reset Clears the input metering values stored in the meter.
Related Topics
• Peak demand
Performing meter resets using the display
You can perform meter resets from the display after entering a valid password.
Revenue-locked meters must be unlocked to perform resets that impact revenue data.
Your meter’s digital and analog outputs may change state or may not function during
resets.
WARNING
HAZARD OF UNINTENDED OPERATION
Failure to follow these instructions can result in death, serious injury or
equipment damage.
Do not use the meter for critical control or protection applications where human or
equipment safety relies on the operation of the control circuit.
Meter resets clear the meter’s onboard data logs and other related information.
NOTICE
DATA LOSS
Failure to follow these instructions can result in data loss.
Ensure all important data from the device has been retrieved before performing a
reset.
1. Navigate to Setup Menu > Resets.
Enter your login credentials, if requested.
2. Press the edit button to access the configuration menu and use the up and down
buttons to navigate through.
3. Press the up and down buttons simultaneously to select the resets you want to
perform
4. Press the select button to perform the resets.
When you select Master Reset, the message
ALL RECORDED DATA WILL BE LOST. RESET
SELECTED PARAMETERS
? is displayed. Press the select button to confirm the master
reset.
7EN05-0336-03 165
To Next Page
Loading...
