Siemens 9410 Series - Page 65

Communications 9410 series
permanently lose the ability to change your device’s configuration and access to
additional data.
NOTICE
LOSS OF ACCESS
Failure to follow these instructions can result in loss of access to the device.
Ensure you maintain sufficient access to communicate with and configure your
device.
1. Open the Setup Assistant for your meter.
See the ION Setup Help for instructions.
2. Select Communications > Advanced Ethernet and click the Protocols tab.
Enter your login credentials as required.
3. Select a protocol from the list and click Edit.
4. Select the Enabled checkbox to enable the port. Clear the checkbox to disable
the port.
NOTE: The IEC61850 port is enabled when a valid CID file is uploaded to the
meter. The port is disabled by removing the CID file.
NOTE: For EtherGate functionality, the EtherGate protocol must be enabled
and the applicable serial port set to EtherGate.
5. Select a port number from the Port Number dropdown list or by clicking in the
Port Number field and entering a port number.
6. Click OK.
If multiple ports are set to the same number, ION Setup responds with a message
indicating that the port is already in use by another protocol.
NOTE: When configuring the FTP ports, the data connection port is
automatically assigned to the command connection port number minus 1. For
example, if the command connection port number is 21, the data connection
port number is automatically set to 20.
Network protocol control using the meter webpages
Use the meter webpage to enable, disable or change the port number of the network
protocols supported on your meter.
The Setup tab contains configurable elements for enabling, disabling and changing the
port numbers for your network protocols.
When configuring communications parameters, ensure you maintain at least one
communication path that allows full access to your device; otherwise you may
permanently lose the ability to change your device’s configuration and access to
additional data.
NOTICE
LOSS OF ACCESS
Failure to follow these instructions can result in loss of access to the device.
Ensure you maintain sufficient access to communicate with and configure your
device.
7EN05-0336-03 65