9410 series Alarms and alerts
Default alarms
Your meter comes with default alarms.
NOTE: Some alarms require configuration in order to operate.
Name Priority Description
Current Sag Ph1 - 3 High Current sag alarms for phase 1, 2, 3
Current Swell Ph1 - 3 High Current swell alarms for phase 1, 2, 3
Sag/Swell High Voltage sag/swell alarm
Over I unbal Medium Over unbalanced current alarm
Over V unbal Medium Over unbalanced voltage alarm
Over THD V1 - 3 Medium Over total harmonic distortion (THD) voltage alarms
Over kW (P) sd Medium Over kW sliding demand alarm
Over I a - c, (1 -3) 4 Medium Over current alarms
V1 - V3 Setpoint Medium Voltage setpoint alarms
Freq Setpoint Medium Frequency setpoint alarm
4-30 Volt Intrp Ph1 - 3 Low 4-30 voltage interruption power quality alarms
Digital In Info Only Digital input alarms
Number of alarms determined by the total number of available digital inputs
NOTE: These alarms are not displayed by default.
Alarm information
You can view information about an alarm from your meter’s display.
Only alarms with a priority of low, medium or high are displayed.
Parameter Description
Alarm The name of the alarm (for example, Over THD V1).
Priority Low, medium or high alarm priority.
Date The date and time the alarm was triggered.
Duration The duration of the alarm (only applies to inactive alarms).
Ack The date and time when the alarm was acknowledged (only applies to
acknowledged alarms).
Value Active alarm: The maximum value detected when the alarm was triggered.
Historic alarm: The maximum value detected during the duration of the alarm.
Viewing and acknowledging alarms using the meter’s display
You can view and acknowledge alarms using your meter’s display
1. Press the home button to display your meter’s data screen menu.
2. Navigate to Alarms > Active Alarms to view and acknowledge active alarms, or
navigate to Alarms > Historic Alarms to view and acknowledge alarms that are no
longer active.
130 7EN05-0336-01
To Next Page
Loading...
