Siemens AXIOM Iconos R200 - Tomography (Optional); Programs; Creation of Programs; Temporary Changes of Programs

Examination
Digital Radiography
AXIOM Iconos R200 AXD3-340.620.13.01.02 27 / 52
Programs
The following programs can be stored:
– Single image organ program
– Serialography organ program
– DSA organ program (optional)
Creation of programs
➩ Refer to the FLUOROSPOT Compact Operator Manual.
Temporary changes of programs
For the following parameters stored in the organ program, it is possible to change
them temporarily with the corresponding operating elements:
– Film density
– Switching over from single image/serialography
–Dominants
– Cu prefilter
– Automatic level 1, 2, 3
Tomography (optional)
Selection
◆ Press this key.
– Digital radiography is selected: the LED lights up
◆ Press this key.
– The LED in the start key flashes if the conditions for tomography are not
fulfilled.
– The possible combinations of tomographic angle / tomographic time appear
in the display.
– The selected combination is emphasized.
The changed parameters apply only until you select another / same organ pro-
gram or switch the system off.
DR
DR
DR
s8.0˚8
20˚ 0 . 6s
40 1 . 2s˚
02˚1.2
40˚ 2 . 5s
s
8˚0.4s