System Overview
Operating and Display Elements
AXIOM Iconos R200 AXD3-340.620.13.01.02 39 / 44
◆ To switch the laser line light localizer on, press the button at the front of the
collimator.
◆ To switch the laser line light localizer off, press the button again.
– The laser line light localizer can also be switched off automatically by an
internal time switch.
Crosshairs ❏ The crosshairs project the longitudinal and transverse axis of the radiation field
onto the cassette or directly onto the patient.
◆ The full field light localizer for projecting the crosshairs is switched on with the
button at the front of the collimator.
◆ To switch it off press the button again.
– The full field light localizer can also be switched off automatically by an
internal time switch.
❏ The laser line light localizer and the full field light localizer cannot be
switched independently of one another.
Locking spring The locking spring is located on the left guide rail at the underside of the
collimator.
The locking spring locks the compensating filters, templates etc. inserted in the
accessory rails of the collimator, thus securing them against falling out.
◆ To remove the accessories, press the locking spring to the left until the com-
pensating filter, template etc. can be removed from the collimator.
Caution
Beam of laser light localizer strikes patient’s or user’s eye
Risk of visual disturbance
Eye injury
◆ Do not look into laser beam.
◆ Take care that neither you nor any other person look directly into the light
beam.
◆ Close the laser radiation exit of the Laser light localizer with the sliding cover
to protect the eyes of the patient or any other person.
Caution
Long operating time of light localizer lamp
Overheating of housing and danger of burns
◆ Take care when touching the collimator housing
To Next Page
Loading...
