Installation instructions en
25
17.9 Preparing the appliance
If you install your appliance in a tall unit, you must pre-
pare the appliance.
1.
Remove the middle screw on the base of the mi-
crowave.
2.
Remove the cover at the base of the microwave.
3.
Screw the middle screw tightly on the base of the
microwave.
4.
Loosen the two outer screws on the microwave
base.
5.
Secure the built-in frame on the microwave base
with the two outer screws.
6.
Secure the four supporting feet to the base of the
microwave.
17.10 Installing the appliance
1.
Secure the spacers to the appliance in accordance
with the wall thickness.
To Next Page
Loading...
