Siemens BI710C1B1

en Installation instructions
20
7.
Fit the two plastic covers on the left and right of the
profile.
8.
Insert the power cable into a protective contact
socket.
The power cable must not touch the rear and base
of the appliance after installation.
Adjusting the appliance front
Adjust the appliance front upwards or downwards if ne-
cessary.
1.
Open the appliance.
2.
Undo the screws on the side of the front panel.
3.
Align the appliance front upwards or downwards.
Alignments of maximum -3 to +3mm are possible.
4.
Tighten the screws.
Combining the warming drawer with another
appliance
ATTENTION!
Sharp edges on the appliance may damage the front
panel of the warming drawer.
▶ Do not damage the front panel of the warming
drawer when sliding the appliance in.
1.
Only combine suitable appliances of the same
brand and series.
2.
Install the warming drawer first.
3.
Slide the appliance, on the warming drawer, into the
built-in cabinet.
4.
Note the installation instructions for the appliance.