Siemens Cerberus PRO FC721 - FC721 Options; Fitting Extra Relay

Mounting
Options
5
33 |
118
Building Technologies
A6V10211100_f_en_
--
Fire Safety
2015
-
12
-
15
5.5 Options
5.5.1 Fitting extra relay
Figure 9: Mounting of two relays
1 Fixing screws for the DIN rail 3 Relays 1 + 2
2 DIN rail 4 End clamp for the relays
Mounting steps
1. Insert the relays (3) on the DIN rail (2) and press them down until they latch.
2. Mount the end clamp (4) to secure the relays.
3. Depending on their intended use, connect the relays to the configurable control
outputs of the periphery board. For the pin assignment, refer to the product
characteristics of the respective periphery board.
3
2
1
4