EasyManua.ls Logo

Siemens CM 1243-5 - Product Certifications

Siemens CM 1243-5
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Approvals
CM 1243-5
Operating Instructions, 04/2011, C79000-G8976-C246-01
35
cULus approval
Underwriters Laboratories Inc. meets
Underwriters Laboratories, Inc.: UL 508 Listed (industrial control
devices)
Canadian Standards Association: CSA C22.2 Number 142
(process control equipment)
FM certification
Factory Mutual Research (FM):
certification standard class number 3600 and 3611
Approved for use in:
Class I, Division 2, Gas Group A, B, C, D, Temperature Class T4A,
Ta = 40°C
Class I, Zone 2, IIC, Temperature Class T4, Ta = 40°C
ATEX approval
EN 60079-0:2006: Potentially explosive atmosphere - general requirements
EN 60079-15:2005: Electrical apparatus for explosive gas atmospheres;
Type of protection 'n'
II 3 G Ex nA II T4
Over and above this, the following conditions must be met for the safe deployment of the
product:
Install the modules in a suitable enclosure with degree of protection of at least IP54 to
EN 60529 and take into account the environmental conditions for operation of the
devices.
If the rated temperatures of 70°C at the cable entry or 80°C at the branching point of the
wires are exceeded, the permitted temperature range of the selected cable must be
suitable for the actual measured temperatures.
Measures must be taken to prevent the rated voltage being exceeded by more than 40%
due to transient disturbances.
C-Tick approval
The product meets the requirements of the AS/NZS 2064 standards (Class A)

Related product manuals