Siemens CM 1542-1 - EMC and RoHS Compliance

Approvals
CM 1542-1
Operating Instructions, 07/2019, C79000-G8976-C355-04
45
ATEX approval:
● II 3 G Ex nA IIC T4 Gc
Type Examination Certificate: DEKRA 12 ATEX 0240X
Applied standards:
– EN 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
– EN 60079-15 -Explosive atmospheres - Part 15: Equipment protection by type of
protection 'n'
● II 3 G Ex ec IIC T4 Gc
Type Examination Certificate: DEKRA 18 ATEX 0027X
Applied standards:
– EN 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
– EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased
safety 'e'
The current versions of the standards can be seen in the EC Declaration of Conformity, see
above.
The conditions must be met for the safe deployment of the product according to the section
Notices on use in hazardous areas according to ATEX / IECEx (Page 22).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find here:
● In the SIMATIC NET Manual Collection under
"All documents" >"Use of subassemblies/modules in a Zone 2 Hazardous Area"
● On the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
EMC
Until 19.04.2016 the product meets the requirements of the EC Directive 2014/30/EU
"Electromagnetic Compatibility” (EMC directive).
Applied standards:
● EN 61000-6-4
Electromagnetic compatibility (EMC) - Part 6-4: Generic standards - Emission standard
for industrial environments
● EN 61000-6-2
Electromagnetic compatibility (EMC) - Part 6-2: Generic standards - Immunity for
industrial environments