Siemens CU240S PN-F - Creating a STARTER Project

Commissioning
4.5 Commissioning with STARTER
CU240S and CU240E Control Units, FW 3.2
Operating Instructions, 03/2009, A5E02440075B AA
59
4.5.1 Creating a STARTER project
Description
An inverter can be parameterized in a user-friendly fashion using the Project Wizard. The
commissioning procedure described here follows the Project Wizard. The PC communicates
with the inverter via the USS interface.
● Switch on the inverter supply voltage
● Launch the STARTER commissioning tool.
● Use the Project Wizard and click on the "Find drive units online ..."
Figure 4-4 Start field
● In the screen that follows (not shown here), enter a meaningful name into your project,
e.g. "Basic Commissioning" and click on "Continue". The following dialog box is
displayed.
Figure 4-5 Setting the PC interface
● Click "Change and test..." to set up the PG/PC interface.