Siemens DESIGO PXM10 - Settings on the Device

15/34
Siemens Building Technologies PXM10 operator unit CM110397en
Siemens Building Automation 31.08.2004
If the PXM10 connection is interrupted briefly, it may take up
to 15 seconds for the polling cycle to resume. The display
can be re-enabled by operating any of the operator controls.
There is no need to log out.
Wait 30 seconds before reconnecting.
3.1 Settings on the device
Figure 3-2 Display showing plant data
Step Procedure
1 Press OK to open the Settings menu.
Figure 3-3 Individual entries
2
Set individual values by rotating the dial and
acknowledge the settings with OK. You can also
use OK to move from one input field to the next
within a value.
Logout
STOP
Caution
All manuals and user guides at all-guides.com