Siemens DESIGO RXC - Workflow with RXT10 and LNS plug-in

5 / 20
Siemens RXZ95.1/LON – Gateway EnOcean/LonWorks CM2N1661en_02
Building Technologies Workflow with RXT10 and LNS plug-in 23 Sep 2011
Workflow with RXT10 and LNS plug-in
Basis: PC with DESIGO infrastructure
RXT10 version 4 or higher
Note: The following components must be installed in the order indicated.
Step 1: Installation of L
ONMARK resource files version 13.00 or higher
Source: http://www.lonmark.org/technical_resources/resource_files/
Step 2: Installation of device resource files:
Source: Download from the DESIGO RX intranet:
https://intra.industry.siemens.com/bt/global/en/bus
iness/building_comfort/systems/
desigo/ra/Pages/des-ra-units.aspx?TabcardNo=6
Step 3: Installation of SRC04-FTT plug-in
Source: Download from the DESIGO RX intranet:
https://intra.industry.siemens.com/bt/global/en/bus
iness/building_comfort/systems/
desigo/ra/Pages/des-ra-units.aspx?TabcardNo=6
Set up the gateway with the RXT10 tool by following the standard procedure for
integration of third-party devices (for details, refer to User Manual RXT10,
CM110669).
Step Procedure
1
Device > Add
Select tab Device Type.
From menu Device Type, select PLG: Plug In Support.
On the "Device" list, highlight PlugInDevice.
2
Select tab
Overview and enter the location.
Confirm by clicking
OK.
Infrastructure
Engineering with
RXT10 and
LNS plug-in