EasyManua.ls Logo

Siemens EQ.700 integral TQ715D03 - Dispensing Two Cups at Once; Grinder; Adjusting the Grinding Level

Siemens EQ.700 integral TQ715D03
132 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Grinder en
49
3. Select and press the beverage
symbol for latte macchiato.
To change the strength, press ⁠.
To change the per-cup quantity,
press ⁠.
To change the milk ratio, press
⁠.
4. Press "Start" and wait until the pro-
cess is complete.
To completely stop dispensing
the beverage, press "Stop".
To only stop the current dis-
pensing step, press "Skip".
After preparing the beverage, the
milk system will automatically
clean itself with a short jet of
steam.
Notes
¡ If you do not change any settings
for approx. 30seconds, the appli-
ance will exit settings mode.
¡ The appliance saves the settings
automatically.
Tips
¡ You can also pre-heat cups before
dispensing using hot water or the
cup heater
1
.
¡ You can also use plant-based al-
ternatives to milk, e.g. soya milk.
¡ The quality of the milk froth de-
pends on the type of milk or plant-
based alternative used.
7.6 Dispensing two cups at
once
Depending on your beverage, you
can make 2 cups at the same time.
Note:If the "doubleShot" or
"tripleShot" function is active, the
function for dispensing two cups at
once is not possible.
1. Press the symbol for your desired
drink.
2. Press ⁠.
a The display shows the setting ⁠.
3. Place two cups on the left and
right underneath the beverage out-
let.
4. Press "Start".
The beverage is prepared in 2
steps. The beans are ground in 2
grinding operations.
a The beverage is brewed and then
runs into the cups.
5. Wait until the process is complete.
Grinder
8 Grinder
Grinder
Your appliance has an adjustable
grinder, which you can use to cus-
tomise the grinding level of your cof-
fee beans.
8.1 Adjusting the grinding
level
Set the desired grinding level while
the coffee beans are being ground.
WARNING
Risk of injury!
The grinder rotates.
Never reach into the grinder.
ATTENTION!
Risk of damage to the grinder. The
grinder may be damaged if the grind-
ing level is not set properly.
Only set the grinding level when
the grinder is running.
Select the grinding level using the
rotary selector step by step.
1
Depending on the appliance specifications

Table of Contents

Related product manuals