Siemens ET 200pro - Connecting the IM 154-4 PN High Feature Interface Module with CM IM PN PP FO

Connection
4.10 Connecting the IM 154-4 PN High Feature Interface Module with CM IM PN PP FO
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
103
4.10
Connecting the IM 154-4 PN High Feature Interface Module with
CM IM PN PP FO
Introduction
You connect the power supplies and PROFINET IO (optically via fiber-optic cables) to the
CM IM PN PP FO connection module. The IM 154-4 High Feature interface module is
equipped with an internal PROFINET switch. This allows direct looping through of
PROFINET IO, or the direct connection of a further IO device.
X03 DC 24V Push-
pull socket (with male connector) for feeding the 1L+ electronics/encoder supply
and the 2L+ load voltage supply
X04 DC 24V Push-pull socket (with male connector) for looping the 1L+ electronics/encoder supply
and the 2L+ load voltage supply
X02 P1 R
Push-pull socket for SC RJ for feeding of PROFINET IO (fiber-optic cable)
X02 P2 R
Push-pull socket for SC RJ for looping through of PROFINET IO (fiber-optic cable)
Requirements
The IM 154-4 High Feature interface module (including the bus module) and the
CM IM PN PP FO connection module have been installed on the rack.
Required tools
● Screwdriver
● Stripping tool for wiring the push-pull cable connector, if you are fabricating your own
cables.