EasyManua.ls Logo

Siemens ET 200S - Terminal Modules

Siemens ET 200S
564 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ix
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Contents
Introduction
1 Product Overview
1.1 What Are Distributed I/O Systems? 1-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.2 What Is the ET 200S Distributed I/O System? 1-4. . . . . . . . . . . . . . . . . . . . . . .
1.3 Guide to the ET 200S Manuals 1-10. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2 Brief Instructions on Commissioning ET 200S
3 Configuration Options
3.1 Finely-Graduated Modular System 3-1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.2 Placement and Connection to Common Potential of Power Modules 3-3. . . .
3.3 Configuration Options of the Interface Modules 3-5. . . . . . . . . . . . . . . . . . . . . .
3.4 Configuration Options between the Terminal Modules and
Electronic Modules 3-8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.5 Direct Communication 3-24. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.6 Clocking 3-25. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.7 Limitations on the Number of Modules That Can Be Connected/
Maximum Configuration 3-30. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4 Installation
4.1 Installation Rules, Installation Position, Rail, Installation
Measurements and Clearances 4-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.2 Installing the Interface Module 4-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.3 Installing the TM-P and TM-E Terminal Modules 4-6. . . . . . . . . . . . . . . . . . . . .
4.4 Replacing the Terminal Box on the Terminal Module 4-8. . . . . . . . . . . . . . . . . .
4.5 Installing the Terminating Module 4-10. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.6 Installing the Shield Contact 4-11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.7 Applying Slot Number Labels and Color Identification Labels 4-13. . . . . . . . . .
4.8 Setting the PROFIBUS Address 4-15. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Table of Contents

Related product manuals