Installation
4-11
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Removing the Terminating Module
1. Use a screwdriver to push the locking mechanism on the last terminal module
down until the mechanism stops, and move the terminating module to the right.
2. Tip the terminating module so that it comes off the rail.
4.6 Installing the Shield Contact
Features
You need the shield contact to connect cable shields (for example, analog
electronic modules, 1Count 24V/100kHz electronic module and 1SSI electronic
module).
You fit the shield contact on the terminal module.
The shield contact consists of a shield contact element, a conductor rail,
(3 x 10 mm), a shield terminal, and a ground connection terminal.
Requirements
The terminal modules must be installed.
Tool Required
3-mm screwdriver
Metal-cutting saw
To Next Page
Loading...
