Siemens ET 200SP HA - 3.2 Schematic circuit diagram

In the example below, the con󹪝guration of the shared device is described based on the PROFINET
IO device ET 200SP HA (IM 155-6 PN HA) on a SIMATIC CPU 410-5H.
Preparation
1. Create a project with the name "Shared device project".
2. Add the two stations (SIMATIC 410).
3. Open the stations in the hardware con󹪝guration and con󹪝gure a CPU with PROFINET
interface (a CPU 410-5H in the described case).
4. Assign parameters to the PROFINET interfaces of the stations created this way.
5. "Save and compile" the individual stations.
Creating a shared device
1. Open one of the previously created stations in the hardware con󹪝guration in the
con󹪝guration tool.
2. Con󹪝gure a PROFINET IO device ET 200SP HA (IM 155-6 PN HA) with its own I/O modules.
3. Copy the created IO device.
4. Save the hardware con󹪝guration and close the con󹪝gured station.
5. Open the other previously created station in the hardware con󹪝guration in the con󹪝guration
tool.
6. Add the IO device as shared device.
7. Save and compile the hardware con󹪝guration and close the hardware con󹪝guration in the
con󹪝guration tool and the project.
Result
The shared device is created. You assign the submodules to the con󹪝gured stations.
Assigning submodules
The submodules must be assigned separately for each station. Note that changes to one station
a󹪜ect other station(s). A submodule can only be assigned to one station.
1. Open the properties of the PROFINET IO device in the 󹪝rst station.
2. Con󹪝gure the access to the individual submodules.
3. Save and compile the station and close it.
4. Repeat steps 1 to 3 for the second station.
5. Finally, download the con󹪝guration to the stations.
Product overview
3.4 Shared Device
IM 155-6 PN HA
Equipment Manual, 09/2021, A5E39262148-AE 13