Siemens et 200sp - Page 103

Configuring/address space
4.5 Frequency output mode
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
102 Manual, 05/2019, A5E35061186-AB
Parameters of the TM Pulse 2x24V in "Frequency output" mode
The default settings of the parameters are shown in bold in the "Value range" column.
Table 4- 14 Adjustable parameters
Parameter
Value range
Scope
Channel configuration
1
•
2 channels (2 A)
•
1 channel (4 A)
Module
Reaction to CPU STOP
•
Output substitute value
•
Continue operation
Channel
Substitute value for DQA
•
0
•
1
Channel
Substitute value for DQB
•
0
•
1
Channel
Group diagnostics
•
Deactivated
•
Activated
Channel
Diagnostics DQA
•
Deactivated
•
Activated
Channel
Diagnostics DQB
•
Deactivated
•
Activated
Channel
High-speed output (0.1 A)
•
Deactivated
•
Activated
Channel
Function DI
•
Input
•
HW enable
Channel
Input delay for digital inputs
•
None
• 0.05 ms
•
0.1 ms
• 0.4 ms
• 0.8 ms
• 1.6 ms
• 3.2 ms
• 12.8 ms
•
20 ms
Channel
On delay for pulse output
0...85000000 μs
Channel
1
When configuring with HSP for STEP 7 or with a GSD file, you define the channel configuration by
the selection of the module name.
Note
PROFIBUS GSD configuration
When configuring with a PROFIBUS GSD file, the possible parameter assignments are not
available. The parameters are preassigned in the module with the default setting. Set the
"Frequency output" mode and the further parameters in the user program using data record
128.