Configuring/address space
4.6 PWM with DC motor motor
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
123
The figure below shows an example of a 1:3 ratio of application cycle to period duration with
a duty cycle of 50%.
Note
No HW enable or On delay
No hardware enable or On delay can be used in isochronous mode.
If you configure the hardware enable in isochronous mode, th
is is interpreted by the module
Further information
You will find a detailed description of isochronous mode in:
● In the isochronous mode function manual as a download from the Internet
(https://support.industry.siemens.com/cs/ww/en/view/109755401).
● PROFINET with STEP 7 function manual available for download on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/49948856).
To Next Page
Loading...
