Configuring/address space
4.7 Parallel connection of channels
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
125
The figure below shows one-channel operation in which you only configure Channel 0.
Figure 4-13 One-channel operation (parallel connection)
The following table presents the possible load current depending on whether or not the high-
speed output is activated:
High-speed output deactivated
High-speed output activated
Two-channel opera-
2 A 100 mA
One-channel mode 4 A Not permitted
You configure the function in the hardware configuration using the "Channel configuration"
parameter.
To Next Page
Loading...
